Intellitrax Color Reference Measurement Procedure - X-Rite Set Up And Operation Manual

®
I N T E L L I T R A X A U T O S C A N N I N G

IntelliTrax Color Reference Measurement Procedure

The color reference measurement procedure provides you with a method to check the
performance of your IntelliTrax instrument. A color reference measurement can be
performed at anytime.
NOTE: Use must have the Color Reflectance Reference Data installed on your computer to
perform this measurement procedure.
1. Remove the color reflectance reference from its protective envelope. Make sure that it is
clean before continuing with the measurement procedure. If the color reflectance
reference requires cleaning, refer to the Cleaning the Color Reflectance Reference
explained earlier.
2. Position the color reflectance reference on the track, next to the scribe line by the
scanning head. Make sure the designated side of the reference is positioned up against
the sheet stops.
3. Start the measurement sequence by selecting the Measure Color Reference button in
the Press Tool. View the monitor for measurement results.
4. Select the appropriate option in application to start the calibration check. The scanning
head moves across the color reflectance reference and then back to its docked position.
The indicator light flashes green during the reading and then turns to solid green after a
successful reading. This is also verified on the computer monitor.
If the calibration check fails (indicated on the computer monitor), clean the color
reflectance reference and instrument optics as explained earlier, and perform the
calibration check again. If the calibration check fails again, contact your X-Rite
representative. You may need to replace your color reflectance reference (Part Number
ATS40-64).
5. Return the color reflectance reference back to its protective envelope.
20
S Y S T E M
Color Reflectance Reference
Scribe line
Sheet Stops