Color Accuracy Test - X-Rite Pantone Virtual Light Booth User Manual

COLOR ACCURACY TEST

To check if the color accuracy of the VLB display deviates from the original factory calibration you
can perform a color accuracy test at any time. The procedure is similar to the light calibration.
1. Tap the Service button on the Home screen of the touchpad to access the Settings screen.
2. Tap the Calibration button on the Settings screen to start the procedure.
3. Connect the i1Pro and perform the light calibration. Refer to the Light Calibration section for
additional information.
4. After the light calibration, mount the i1Pro on the i1Pro calibration holder and place it in front of the
monitor. Make sure that it is centered and is 5-10 cm from the front of the monitor.
5. Dim the room illumination for the usual viewing conditions. Do not install the calibration curtain or
mount the ambient light head on the i1Pro.
6. Start the measurements by tapping the Next Step button.
7. A series of 24 patches of the ColorChecker is displayed on the monitor and measured with the
i1Pro.
8. After the measurement the average delta E to the factory calibration is calculated and displayed.
V i r t u a l L i g h t B o o t h
25