Removing The Scanning Head - X-Rite Set Up And Operation Manual

Removing the Scanning Head

The following procedure explains how to remove the scanning head in the event
maintenance is required.
1. Unplug the IntelliTrax system from the power adapter and slide the scanning head at
least 5 inches (127 mm) away from the docking station.
2. Lift the access cover on the back of scanning head to gain access to the locking lever.
3. Rotate the lever 90° clockwise.
4. Compress the two locking tabs located on both sides of the scanning head connector. It
may be helpful to use a pair of needle-nose pliers to gain access to the locking tabs.
5. Pull the connector outwards to free it from the scanning head.
6. Lift up under the front edge of the scanning head and tilt it back to expose the bottom.
7. Holding the scanning head with one hand, carefully remove the four Phillips-head screws
securing the scanning head to the trolley.
Screws (2)
8. Lift the scanning head free from the trolley.
I N T E L L I T R A X
Access Cover
Scanning Head Connector
Screws (2)
®
A U T O S C A N N I N G S Y S T E M
19