Overview Of Installing In A Customer Cabinet - EMC VNX5300 Block Installation Manual

Overview of installing in a customer cabinet

If your system was shipped to be installed in your own cabinet, the installation process involves
the following:
1. Read and complete the prerequisite tasks listed in
2. Unpack the shipping boxes and verify the shipping contents as described in
system" on page
3. Remove shipping container contents and assemble the components in your cabinet as
described in
4. Cable your system as described in
5. Power up your system by connecting power cables, and then verify that the system powered
up correctly by checking the LEDs of the components as described in
6. Optionally, you can add a disk array enclosure (DAE), power it up and then verify that the DAE
was powered up correctly by checking the DAE LED status as described in
storage" on page
7. Complete the tasks listed in
EMC VNX5300 Block Installation Guide
6
9.
"Assemble components in your cabinet" on page
"Cable your system" on page
25.
"Setup" on page
"Before you begin".
11.
17.
35.
"Unpack your
"Power up" on page 21.
"Add additional