LifeShield home security system Setup Manual page 13

10
Add Handset (if included)
Install the Handset and Charger
INSTALL BATTERY PACK
Open the Battery compartment
A
Insert the Battery plug into the two-pin jack,
B
and insert the Battery.
Replace the Battery cover
C
NOTE: USE ONLY THE LIFESHIELD
LS80 BATTERY PACK.
ADD THE HANDSET
- Attach Belt Clip
- Snap the Belt Clip onto the sides of the Handset
CONNECT THE CHARGING CRADLE
- Connect the Charging Cradle power adapter to the bottom
of the Charging Cradle and to the electrical wall outlet.
CHARGE THE HANDSET
Place the Handset in the Charging Cradle. When properly seated
on the cradle, the amber light on the front of the cradle will be illuminated.
NOTE: Immediately place the Handset in the Charging Cradle that came packed with the Handset. THE HANDSET MUST
BE CHARGED FOR AT LEAST 30 MINUTES PRIOR TO ATTEMPTING ANY SECURITY SYSTEM INSTALLATION. IT MUST BE
CHARGED FOR 2 HOURS BEFORE MAKING PHONE CALLS.
NOTE: THE PHONE SYSTEM COMES WITH VARIOUS SETTINGS PRE-DEFINED FROM THE FACTORY. SHOULD YOU WANT
TO CHANGE THESE SETTINGS, WE SUGGEST WAITING UNTIL AFTER YOU ACTIVATE YOUR SYSTEM. THESE SETTINGS
INCLUDE RING TONES, RING VOLUME, DISTINCTIVE RINGING, DISPLAY CONTRAST, ETC.
ADD THE HANDSET TO YOUR LIFESHIELD SYSTEm
Follow these steps for adding an additional Handset to a LifeShield system. Handsets packed with kits are pre-registered and
do not require these steps.
After the initial installation of the LifeShield System, devices may be added to enhance
access or performance.
The maximum number of devices that can be added to a LifeShield System is shown
in the table to the right. After the Handset and Charger are installed, use a Handset
or Console that is already registered on the System to add the new Handset.
ADD THE HANDSET
On an Existing Handset or Console, use the SCROLL and SELECT buttons to
A
navigate to GC or Handset (Menu/Security Setup/GCs or Handset/<Add New>)
Press the SELECT key to <Add New>. The system will begin searching for a new Handset.
B
C On the new Handset, press the SEARCH key
the system display and audio signal will inform you the Handset is found.
D
you will then be given the option to edit the default name.
E
use delete to erase the current name and replace with new text by using the keypad.
F
*Note: Wherever Master Code is shoWN P
INSTALL
BATTERY PACK
lease use your uNique Master Code FouNd iN the FroNt Cover oF this book
* The system will allow a maximum of 8 Handset/Console
or Grid Extender combinations.
ADD THE HANDSET
* The system will allow a maximum of 8 Handset/Consol
* The system will allow a maximum of 8 Handset/Console
or Grid Extender combinations.
or Grid Extender combinations.
12