LifeShield home security system Setup Manual page 12

9
Add Indoor Camera Model RC8221 (if included)
The RC8221 is an indoor camera with built-in Infrared LEDs for night vision.
TO USE
First plug Ethernet cord into camera and router.
A
Wait for Power LED to stay solid
B
On console select menu > Cameras > Add New
Once all cameras are found, press OK
C
Log in to LifeView and select Camera > Camera
D
Settings > Edit.
A. Enter SSID or Network Name, wireless
connection security type and password
*Entries are case sensitive, spelling and
spacing must be exact
Once Wifi* information has been saved wait
E
2 minutes before unplugging the power and
then Ethernet
After 2 minutes, plug power back into camera and
F
leave Ethernet unplugged. Once power light is solid
the camera is wireless and ready for final placement.
*If the camera works while connected to
the Ethernet but not wirelessly then the
WiFi* information must be verified. Repeat
step D if necessary.
NOTES
Must be on same router as your LifeShield Base to
setup. After setup, plug into power where you like
Setup WiFi using camera Settings in LifeView,
disconnect Ethernet cable, then remove and
reconnect the power
Setup alerts in LifeView to take pictures when
sensors tigger
Live video per session is 5 minutes
If the camera works while connected to the Ethernet
but not wirelessly then the WiFi information must be
verified. Repeat step D if necessary.
*Wireless, or WiFi, technology allows an electronic
device to exchange data wirelessly (using radio
waves) over a computer network
11
A
POWE POWER
POWE POWER
PRIVACY PRIVACY V V
PRIVACY PRIVACY V V
WPS
To reset, insert paperclip into
RESET
reset button (next to power
connector) for at least 5 seconds
POWER POWER
WPS
and release
NETWORK NETWORK
RESET
POWER POWER
NETWORK NETWORK
DO NOT use the WPS Button,
Micro SD Slot, or green wire
connector