Mytee Speedster 1000DX-200 Instructions Manual page 22

1005DX SPEEDSTER
1005DX SPEEDSTER
HOSE CONNECTIONS
Attach one end of a solution hose to a wand or other tool, the other
end to the Speedster's® front quick disconnect. Attach one end of
a vacuum hose to the tool, the other end to the Speedster's® Cuff-
Lynx™ vacuum hose port.
1005DX SPEEDSTER
Lift lid and manually fill the tank.
VAC/SOL
®
FILL SOLUTION TANK
®
1005DX SPEEDSTER
"On" switches are located on the plate in front of the machine. To
use vacuums, turn on Vac 1 and Vac 2 switches. To use pump,
turn on Pump switch. Bottom right switch has no use.
1003DX SPEEDSTER 1005DX SPEEDSTER
& PRESSURE REGULATOR & PRESSURE REGULATOR
PRIME POSITION PRIME POSITION
RUN POSITION RUN POSITION
Prime the pump by turning the valve to the Prime position (as Prime the pump by turning the valve to the Prime position (as
shown above) for 30 seconds, then turn right to the Run position. shown above) for 30 seconds, then turn right to the Run position.
Turn the Pressure Regulator to the left to decrease water pres- Turn the Pressure Regulator to the left to decrease water pres-
sure. Turn the Pressure Regulator to the right to increase water sure. Turn the Pressure Regulator to the right to increase water
pressure. pressure.
22
SWITCHES
®
Vac 1 Vac 2
Pump
PRIME VALVE PRIME VALVE
® ®
HIGHER PSI HIGHER PSI
PRESSURE PRESSURE
REGULATOR REGULATOR
LOWER PSI LOWER PSI