Switching The Headset On/Off; Switching The Bluetooth Function On/Off - Sennheiser S1 DIGITAL User Manual

Using the S1 DIGITAL

Switching the headset on/off

Set the Power OFF/ON switch to the position ON.
TM
ON NoiseGard /digital is switched on. The Power LED lights up,
indicating the battery charge status or power supply via the
on-board DC power supply system.
TM
OFF NoiseGard /digital is switched off. The Power LED goes off.
OFF
When the S1 DIGITAL, and thus NoiseGard
it can be used as a conventional, passive headset.

Switching the Bluetooth function on/off

Switch the headset on to use the Bluetooth function.
Switching the Bluetooth function on
Press and hold the multi-function button
blue. You hear an ascending beep.
– When switching the Bluetooth function on for the first time, the
headset will automatically go into pairing mode.
– When the headset is already paired with a Bluetooth device, the
Bluetooth connection is automatically established. You hear a beep
in the headset.
– When the headset is already paired with a Bluetooth device but the
Bluetooth device is switched off or out of range, the
blue. The headset will try for 3 minutes to connect to one of the up to
8 previously paired Bluetooth devices. If this fails, the Bluetooth
function automatically switches off after 10 minutes.
Switching the Bluetooth function off
Press and hold the multi-function button
3 times red.
You hear a descending beep. The Bluetooth function is automatically
deactivated.
If you switch the Bluetooth function off, NoiseGard
remains switched on.
ON
TM
/digital, is switched off,
until the LED flashes
LED flashes
until the LED flashes
TM
S1 DIGITAL
/digital
| 15