Adjusting The Headset To The Listening Situation - Sennheiser S1 DIGITAL User Manual

Using the S1 DIGITAL
16 | S1 DIGITAL

Adjusting the headset to the listening situation

Adjusting the volume
WARNING
Danger of hearing damage!
Listening at high volume levels for long periods can lead to perma-
nent hearing defects.
Before putting the headset on, set the volume to a low level.
Do not continuously expose yourself to high volumes.
The control unit features a Master
to adjust the volume for the left and right channel separately. Using the
Master VOLUME slide control you simultaneously adjust the volume for
both ATC communications and your connected Bluetooth device.
1 Use the Master VOLUME
able level.
2 Use the Volume button and the Volume
ume of your connected Bluetooth device to the volume for ATC commu-
nications.
1
Vol + Vol +
Vol – Vol –
Switching between mono and stereo mode
The control unit features a mono /stereo
to switch between mono and stereo mode, depending on the intercom.
Set the mono /stereo
= mono
= stereo
Using Smart Update
The noise level in the cockpit changes depending on the flight situation.
Whenever you perceive a change in the noise level (e.g. during take off and
when the cruise altitude is reached), you should perform the Smart Update
in order to ensure optimum noise compensation at any given time.
The outer and inner microphones measure the sound and NoiseGard
digital is adjusted accordingly via the electronics. Smart Update only works
when the headset is switched on.
Press the Smart Update button.
The Smart Update button lights up for approx. 4 seconds and you hear
an acknowledgement tone, indicating that NoiseGard
adjusted to the noise level.
VOLUME slide control which allows you
slide control to adjust the volume to a comfort-
button to adjust the vol-
2
F
switch
F
switch to the desired position:
Vol +
Vol –
which allows you
TM
/
TM
/digital is