When Other Messages Appear - Ricoh MP 2553 Series Read Me First

10. Troubleshooting

When Other Messages Appear

Message
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
"Cannot connect with the
Bluetooth interface. Check
the Bluetooth interface."
"Clean the scanning glass.
(Located next to the
exposure glass.)"
"Following output tray is full.
Remove paper."
224
Causes
• The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
• The settings are not
updated although the
unit is detected.
• The Bluetooth interface
unit was installed while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
The scanning glass or guide
plate of the ADF is dirty.
The output tray is full.
Solutions
Turn off the power, and then confirm
the wireless LAN board is inserted
correctly. And then, turn on the power
again. If the message appears again,
contact your service representative.
Turn off the power, and then confirm
that the Bluetooth interface unit was
installed correctly. And then, turn on
the power again. If the message
appears again, contact your service
representative.
Clean them. See "Maintaining Your
Machine", Maintenance and
Specifications.
Remove paper from the output tray to
resume printing. If paper is destined for
the finisher shift tray, to prevent paper
from falling off the tray press the [Stop]
key to suspend printing, and then
remove the paper. Press [Continue] on
the display panel to resume printing.