Ricoh MP 2553 Series Read Me First page 126

3. Copy
Copying onto Custom Size Paper from Tray 1
or the Bypass Tray
Paper that has a horizontal length of 148.0–432.0 mm (5.83–17.00 inches) and a vertical length of
100.0–297.0 mm (3.94–11.69 inches) can be fed in from Tray 1. Paper that has a horizontal length of
148.0–600.0 mm (5.83–23.62 inches) and a vertical length of 90.0–305.0 mm (3.55–12.00 inches)
can be fed in from the bypass tray. Note however that the limitation on the horizontal and vertical length
range will vary depending on which options are installed.
• When prints are delivered to the internal shift tray, Internal Tray 1, or the tray of the internal
finisher:
Horizontal length: 148.0–600.0 mm (5.83–23.62 inches), vertical length: 90.0–305.0 mm
(3.55–12.00 inches)
• When prints are delivered to Internal Tray 2:
Horizontal length: 148.0–460.0 mm (5.83–18.11 inches), vertical length: 100.0–305.0 mm
(3.94–12.00 inches)
• When prints are delivered to the tray of the booklet finisher or 1000-sheet finisher:
Horizontal length: 148.0–600.0 mm (5.83–23.62 inches), vertical length: 90.0–304.8 mm
(3.55–12.00 inches)
• The Duplex function cannot be used with custom size paper. If the Duplex function is specified,
press [1 sided
• When loading custom paper into Tray 1 and making copies, be sure to specify the paper size. If
you do not specify the paper size, a paper jam may occur.
1. Load the paper face up into Tray 1 or face down in the bypass tray.
The bypass tray (
from the bypass tray.
To copy from Tray 1, select Tray 1.
2. Press the [ ] key.
3. Press [Paper Size].
4. Press [Custom Size].
80
2 sided:TtoT] to cancel the setting.
) is automatically selected, so you do not need to make a selection to copy