Simrad AP26 Manual page 44

Source Select
Manual source select
Step through the list of sources using the PORT or STBD
button. Select wanted source by rotating the course knob.
– – indicates that no source is supplying the data available.
Notes !
1. Simrad products will be identified by the product name
2. See note on page 69 and note 3 below.
3. In the event the SimNet is not powered on, sources
20222147A
Provides you with automatic or manual selection of
interfaced data sources for heading (Compass),
Navigation, Position, Wind Angle, Calculated Wind,
Water speed, Water temperature, Distance log (not
displayed on AP26 and AP27) and Depth.
Wind-C (calculated) is a common term for true wind
and wind direction.
Auto source update
Is used for automatically update of sources if the
interfaced units have been removed/added or
switched on/off.
Select Auto source update by rotating the course
knob. Make sure all interfaced units are powered on
The autopilot will search for new connected sources,
and replace sources no longer available.
"SEARCHING" is flashing as long as the autopilot is
searching. When the automatic update is finished, the
display will read "DONE".
Press the STBD button to leave the User setup.
provided the data is available on SimNet. If speed data is
provided from the Volvo IPS system to the autopilot
computer, the display will read IPS.
supplying data to SimNet are not on or malfunctioning, or
there is no SimNet installed, it is possible to use any
control unit in the system to select IPS as speed source.
The source select displays are then available on all control
units.
Operation
43