Sending Dtmf Tones; Using Memory - Nokia 9000 User Manual

daphne.frm Page 4 Wednesday, January 15, 1997 1:48 PM
14-4

Sending DTMF tones

If you need to send long DTMF strings, it is more
convenient to send them within the communica-
tor interface, see chapter 4 "Telephone: Manag-
ing calls - Sending DTMF tones".
Make a call to the desired phone number.
Key in the digits you want to send as DTMF
tones. The digits are sent one by one to the
network. DTMF tones can be transmitted even
when the keypad tones are set off.
Automatic transmission
In order to send DTMF tones automatically, you
must store them first. Storing DTMF strings is
most conveniently done in the communicator in-
terface, see chapter 3 "Contacts: Contact cards -
Storing DTMF tones". If you want to store DTMF
strings in the phone interface, see "Using memo-
ry: Storing information via the phone interface".

Using memory

The phone numbers and names you store are nor-
mally located in the standard memory of the
communicator, indicated by the letter "B" on the
phone interface display.
The "B" memory is the communicator memory,
called the Contacts directory. When the commu-
nicator is started-up for the first time, the "B"
memory is selected automatically.
The "A" memory is located on the SIM card that
is inserted in the communicator. The SIM card
memory uses numbered memory locations to
store data. When numbers are saved in the SIM
card ("A") memory, a message will indicate its lo-
cation number. The number of standard memory
locations available on SIM cards varies from one
card to another.
When the "A" memory is selected, the phone in-
terface stores all contact information on the SIM
card and cannot access the Contacts directory.
Sending DTMF tones
Press Memory. Key in the name of the contact
card which contains the DTMF service phone
number and the DTMF digits and press Find.
For how to recall information, see "Using
memory: Recalling information".
Note: When stored DTMF tones are recalled in
the phone interface, only DTMF strings which
have been stored in a Tel field can be used.
When the recalled string (containing the
phone number and the DTMF digits) is on the
display, press .
After the connection has been established,
the DTMF tones will be sent directly, after a
small pause (if the sequence contained the p
character) or after you press
ond time (if the sequence contained the w
character).
Therefore, the use of the communications appli-
cations of the communicator interface will be
less convenient (you will have to enter most con-
tact information manually). This manual will as-
sume that you use the standard "B" memory.
Keying in a name
Press the Memory selection key to switch to
the alpha mode (the indicator is shown
on the phone interface display).
Press the key that has the desired character.
If the character that you want is not the first
to be displayed, press the key again within
one second (before the cursor appears) to dis-
play the next character. Keep pressing the key
until the desired character appears.
If you miss a character, keep pressing the key
until it appears again; or first press
then start pressing the key again.
for the sec-
and