Incoming Faxes, Short Messages And Data; Telephone Settings - Nokia 9000 User Manual

teleph.frm Page 5 Wednesday, January 15, 1997 2:06 PM
Chapter 4 - Telephone
Sending DTMF tones
The Dual Tone Multi Frequency (DTMF) tones al-
low you to communicate with voice mailboxes,
computerised telephony systems, etc. Sending
DTMF tones is not possible during a conference
call. Besides the numbers 0 - 9, you can also use
the characters p, w, * and # (for information on
the functions of these characters, see chapter 3
"Contacts: Contact cards - Storing DTMF tones").
To send a DTMF sequence when you have an ac-
tive call (remember that the active call must be
selected):
Key the digits from the communicator inter-

Incoming faxes, short messages and data

Faxes, short messages and incoming data are re-
ceived automatically, provided that the phone
interface is on and within cellular coverage area.
While a data/fax connection is active (check the
call status indicator), you cannot make calls.

Telephone settings

Pressing Settings in the Telephone main view
opens a list of several settings groups:
Ringing settings, Voice call diverting, Voice call
barring, Voice call waiting, Other settings
To change the settings:
Select a group and press Change to open it.
Select a setting and press Change. The cur-
rent value of the setting is displayed after the
setting name, unless the setting is one the
network services: call diverting, barring or
waiting. See the following sections.
face keyboard. Each keystroke will generate a
DTMF tone which will be transmitted directly.
Or alternatively,
Press Send DTMF. A list of stored DTMF se-
quences is shown (for information on how to
store DTMF sequences, see chapter 3 "Con-
tacts: Contact cards - Storing DTMF tones").
Select a DTMF sequence. You can edit the se-
quence, or, if there are no stored sequences,
you can manually enter the DTMF string into
the field.
Press Send to send the DTMF sequence shown
in the input field, at the bottom of the display.
If you want to make a voice call, you can either
wait until the data/fax call ends, or you can ter-
minate the data/fax call by starting to make a
call normally. When you press Call, you will be
asked if you want to terminate the data call.
Press Terminate to confirm.
Ringing settings
All sounds — Turn the incoming call alert and all
other alarms to Ring , Beep or Silent . When
sounds are set to Silent or Beep , the call status
indicator shows the text SILENT. This setting af-
fects both interfaces. Whatever the chosen set-
ting, an incoming call is always indicated by a
note.
Ringing volume — Adjust the ringing volume (1 is
the lowest, 5 the highest).
Ringing tone — Select the pattern of the ringing
tone. To compose your own ringing tones, select
one of the custom tones and press Compose. See
chapter 11 "Extras: Composer".
4-5