Connectors - Nokia 9000 User Manual

getting.frm Page 2 Thursday, January 16, 1997 4:09 PM
2-2
Slide the card into the SIM card slot (figure 2-
2). Make sure that the gold contacts of the
SIM card are facing down and the bevelled
corner of the card is on the right side.
Figure 2-2
When the SIM card is properly inserted into
the SIM card slot, the bevelled corner will re-
main visible (figure 2-3).
Figure 2-3

Connectors

(1) IrDA-SIR infrared port for connecting to a PC
or a printer (see figure 2-5). Infrared connections
are described in chapter 10 "System: Connecting
to a PC"
(2) Antenna connector for car installation (see
figure 2-5)
When you are sure that the SIM card is correctly
installed, replace the battery:
Insert the battery in the communicator so
that the side with the four golden connector
plates goes in first (figure 2-4).
Figure 2-4
Push the battery down towards the catch un-
til it clicks into place. Make sure the battery
is properly installed before switching the
power on.
Note: The battery does not fit into place if the
SIM card is not correctly installed. Do not force
the battery into place! Check that you have in-
serted the SIM card into the slot as described
above.
(3) System connector for car installation and for
the adapter (see figure 2-6)
(4) Adapter for connecting the charger and the
RS232 cable to the communicator. The connec-
tor on the left side (5) of the adapter is for the
RS232 cable plug and the one on the right (6) is
for the charger plug (see figure 2-6)
Connectors