Table of Contents
Advertisement
Green PCI/ISA System Board
Note:
After the CMOS has been reset, you must set Jumper J2
to Internal or External Battery Enable. If you set the
jumper to External Battery Enable, make sure you
connect an external battery to Connector J1.
Summary:
* External battery must be connected to Connector J1.
Caution:
The G586VPB system board uses 3V Lithium internal
battery. Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
Cache Configuration
The G586VPB system board can be configured to four
different cache sizes: 256KB (Default size), 512KB,
1MB and 2MB. Either 32Kx8, 64Kx8 or 128Kx8 SRAM
chips are used for cache depending on the size of cache
desired. The G586VPB supports both pure 3.3V and
3.3/5V mixed voltage SRAM. The brands of SRAM that
passed a factory testing are shown on the next page.
2-10 u Installation Overview
J1
Internal Battery
Off
External Battery
On *
CMOS Clean
2-3 On
J2
1-2 On
Off
2-3 On
Advertisement
Table of Contents
