DFI G586VPA User Manual page 50

Green PCI/ISA System Board
If none of the pre-set types is appropriate for your hard
drive, choose "User", which is the user-definable type.
To use this type, highlight the hard disk Primary Master,
Primary Slave, Secondary Master or Secondary Slave,
depending on your hard drive configuration. Use the
arrow keys until type "User" is showing. Fill in all the
parameters as specified by the drive manufacturer. If
either of the drives is not present, select "None" and
press <Enter>.
Drive A and Drive B
These options are used to select the type of floppy disk
drives installed in your system. If either of the drives is
not present, select "None." Make sure you choose the
correct drive type; otherwise, your system might format
the device improperly.
Video
This is used to select the type of video adapter installed
in your system.
Halt on
This option selects when the system will halt if an error
is detected during power up.
No Errors: The system boot will not stop for any
All Errors: The system will stop whenever the BIOS
All, But Keyboard: The system will stop for any
All, But Diskette:
3-4 u Initial Setup Program
errors detected.
detects a non-fatal error.
errors except a keyboard error.
The system will stop for any
errors except a disk error.