DFI G586VPA User Manual page 70

Green PCI/ISA System Board
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS
ENTER
No boot device was found. Insert a system disk into
Drive A and press <Enter>. If you assumed the system
would boot from the hard drive, make sure the control-
ler is inserted correctly and all cables are properly
attached. Also be sure the disk is formatted as a boot
device. Then reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN
SETUP
Type of diskette drive installed in the system is different
from the CMOS definition. Run setup to reconfigure the
drive type correctly.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter
has been changed. You must configure the system for
the new display type.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is
installed correctly and all cables are correctly and firmly
attached. Also, be sure the correct hard drive type is
selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the card is cor-
rectly and firmly installed in the bus. Be sure the correct
hard drive type is selected in Setup. Also, check to see if
any jumper needs to be set correctly on the hard drive.
B-2 u Appendix B