Konica Minolta PagePro 1250W. User Manual page 20

2
Connecting the power cord
WARNING
Use only the power cord shipped with the printer. Using the wrong
power cord may lead to a short-circuit!
The use of a power cord of inadequate cross-section can lead to a short-
circuit.
Only use an extension cable which has a higher rating than the current
consumption of the printer.
Only use grounded cords.
Always observe the relevant local regulations regarding the connec-
tion of electrical equipment to the main network.
The laser printer requires a non-fluctuating power supply. If necessary,
ask an electrician for advice.
Voltage:
Frequency:
1
Make sure that the printer's power
switch is in the "O" (OFF) position.
2
Connect one end of the power cord
to the power cord socket on the
back of the printer, and plug the
other end into a power outlet.
2-10
Installing and setting up the printer
110V - 10%, 127V + 6%, or 220-240V ± 10%
50-60Hz ± 3Hz