Calibrating The System After A Tyre Change; Calibrating The System Manually - Blaupunkt TravelPilot RNS 149 Operating Instructions Manual

Set-up/Basic settings

Calibrating the system after a tyre change

After a tyre change it might be necessary to calibrate the TravelPilot again.
Select CALIBRATION from the Set-up menu Install.
Mark and confirm the menu item TYRE CHANGE .
Follow the instructions given to you by the system.

Calibrating the system manually

You can also calibrate the system manually. To do so, you have to drive a dis-
tance of at least 100 meters at a maximum speed of 30 km/h. Please note that
the distance must be measured out exactly.
Select CALIBRATION from the Set-up menu Install.
Mark and confirm the menu item MANUALLY .
Now you will be required to enter the distance you intend to drive.
Select the first digit indicating the distance and
Press OK 8.
Enter the remaining digits in the same way.
symbol and OK 8 to confirm your entry or press OK 8 for
Press the
a longer time.
You will be instructed to drive this distance.
Use << >> on the rocker switch 7 to select START .
Follow the instructions given to you by the system.
81