Switching On Coded Systems After They Have Been Disconnected From The Vehicle Battery - Blaupunkt TravelPilot RNS 149 Operating Instructions Manual

General operating instructions
Switching on coded systems after they have been discon-
nected from the vehicle battery
f you attempt to switch on a coded system after it has been disconnected from
the vehicle battery, e.g. after a repair has been made to the vehicle, a code
inquiry will appear in the display.
Enter the code number as follows:
Use << >> on the rocker switch 7 to mark the first digit of the code
number,
Press OK 8.
The cursor for the code input will move one position to the right.
Now select the second digit of the code number and press OK 8 to
confirm your selection.
Enter the remaining digits of the code number in the same way.
If you enter an incorrect digit by mistake,
Mark the symbol and
Press OK 8.
Once you have completed entering the code number,
-symbol and press OK 8 to confirm your selection.
Mark the
The system will switch on. If you enter and confirm an incorrect code number by
mistake, you can repeat your entry. To prevent thieves from discovering the
code number by trial and error, the system will be blocked for one hour after an
incorrect code is entered for the third time. The system must remain switched on
for this time to count down. If the system is disconnected from the power supply
during this waiting period, the time will be reset to one hour once again.
Code inquiry
15