Cisco 7961G Phone Manual page 37

If you want to...
Drop the last party added to
the conference
End your participation in a
conference
Join together two standard
conferences on the same line
Verify that a conference call is
secure
Remove a non-secure
participant from a conference
Tips
• To start a secure conference, you must use a phone configured with security.
• Non-secure conferences and participants display a
• Calls must be on the same line before you can add them to a conference. If calls are on different
lines, transfer them to a single line before using Confrn, Conference, or Join. (Join is on SCCP
phones only.)
• Depending on how your phone is configured, if you leave a conference after initiating it, the
conference might end. To avoid this, transfer the conference before hanging up.
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
Then...
Press RmLstC or Remove Last Participant.
Hang up or press EndCall.
On SCCP phones, use the Join or DirTrfr softkeys.
On SIP phones, use the Confrn or Transfer softkeys.
Check with your system administrator to see if this feature is
available to you.
Look for the or
screen.
While viewing the Conference List, locate the participant without the
or icon, and press Remove.
Check with your system administrator to see if non-initiators of a
conference can remove participants.
icon after "Conference" on the phone
icon.
Basic Call Handling
29