KVH Industries TracVision S3 Owner's Manual page 5

Baseplate Connectors Facing Rear
of Vehicle – Factory-drilled
Drain Hole Locations
Baseplate Connectors Facing
Front of Vehicle – Recommended
Drain Hole Locations
You MUST drill out the drain holes
as indicated to ensure that any
moisture that enters the baseplate
is able to drain. Ensure that factory-
drilled holes are completely sealed.
4
10. When the antenna unit is installed with the
connectors facing the rear of the vehicle, the drain
holes are located as shown in Figure 2-4.
Figure 2-4
Drain Hole Positions
10a.(Alternate Drain Hole Locations) If the antenna unit
Figure 2-5
Recommended
Drain Hole Positions
Factory-drilled
is installed with the connectors facing the front of
the vehicle, drill out ⁄
3
rear-facing side of the baseplate as illustrated in
Figure 2-5. The existing factory-drilled drain
holes shown in Figure 2-4 must then be plugged
with silicone rubber sealant.
3/16" (5 mm)
Drain Hole Angle
(relative to baseplate)
" (5 mm)-drain holes in the
1 6
Angle of Hole, relative to front
Angle of Hole, relative to front
Front of
Vehicle
Front of
Vehicle