KVH Industries TracVision S3 Owner's Manual page 6

11. Cut the tie-wraps holding the antenna unit to the
forward shipping restraint (see Figure 2-6).
tie-wraps used
to secure LNB arm
Shipping Restraint
12. Remove the nuts and washers securing the
shipping restraints to the baseplate. The positions
of all three shipping restraints are pictured in
Figure 2-7.
Rotating Plate
Shipping Restraint
Rotating Plate
Shipping Restraint
13. For convenient storage, rotate the shipping
restraints 180º
mounting bolts using the nuts and washers
removed in Step 12 (see Figures 2-8 through 2-10).
All nuts and washers removed in Step 12 must
be reinstalled. These nuts and washers secure the
baseplate to the mounting plates.
LNB
Installation Bolts and Washers
54-0182 Addendum to Rev. A1
Shipping Restraint
Nuts and Washers
and secure them to their original
Forward Shipping Restraint
A Guide to TracVision S3 – ADDENDUM
Figure 2-6
Forward Shipping Restraint
(Arranged for Shipping)
Figure 2-7
TracVision S3 Shipping Restraints
(Top View, Installed for Shipping)
Forward Shipping
Restraint for
LNB Bracket
Do not discard the shipping
restraints, washers, or the nuts.
They should be stowed for future
use in case the antenna unit needs
to be removed and shipped to
another location. Four
head screws have been provided in
the kitpack for shipping as the bolts
used to hold the shipping restraints
during initial shipping are integral
parts of the mounting plates.
Figure 2-8
Forward Shipping
Restraint Storage
1 ⁄ ˝ x 5 ⁄ ˝ hex
4 8
5