Recording And Sdi Output Of External Input Signals - Sony PMW-RX50 Operating Instructions Manual

Setting on this recorder
Set [SDI/HDMI/i.LINK I/O Select] (page 50) in
the [VIDEO SET] menu to [HD & HDV], [SD &
HDV], [SD P & HDV], or [SD & DVCAM].
Recording and SDI Output of
External Input Signals
The recorder supports HDV or DVCAM stream
input from a device connected to the i.LINK
connector, and output to a device connected to the
SDI OUT connector. Input signals can also be
recorded on SxS memory cards in the recorder.
The timecode superimposed on the i.LINK input
is recorded.
1
Set the external signal to a format
supported by the recorder.
1440 × 1080/59.94i, 1440 × 1080/50i, and
DVCAM input formats are supported.
2
In FAT mode, set [SDI/HDMI/i.LINK I/
O Select] (page 50) to [HD & HDV], [SD
& HDV], [SD P & HDV], or [SD &
DVCAM] in the [VIDEO SET] menu.
In UDF/SD mode, set it to [SD].
3
Set [Input Source Select] (page 49) to
[i.LINK] in the [VIDEO SET] menu.
The input signal is output from the SDI
OUT 1/2 connectors.
The video signal is output on the VIDEO
OUT connector and the LCD monitor. The
audio signal is output on the AUDIO OUT
connector, headphone connector, and built-in
speaker.
4
To record, press and hold the REC
button, then press the PLAY/PAUSE
button.
Notes
• An error is displayed if any of the following conditions
occur during recording. When an error is displayed,
press the STOP/EE button to stop recording.
—The video format of the input signal is different to
the recorder format setting.
—A copy-prohibited stream is input.
• If the input signal to the recorder during recording is
lost, the tally lamp and the "zREC" i.LINK status
indication on the LCD monitor start flashing,
indicating that nothing is being recorded on the SxS
memory card.
Recording resumes when the signal is restored, but the
clip number on the recorder is incremented.
• During DVCAM streams, images and audio may skip
or repeat after consecutive operations during DVCAM
streams due to CLK frequency differences between the
DVCAM signal source and recorder.
• During HDV streams, the recorder operates as if
locked to the input HDV signals. Therefore, frequency
shifts in the signal source may cause deviations from
the SDI output signal standards (frequency, jitter, etc.)
Connecting via i.LINK 69