Sony PMW-RX50 Operating Instructions Manual page 8

1.
TC RESET (timecode reset) button
2.
SCAN/SLOW
playback / fast playback) buttons
3.
. > (previous/next clip) buttons
4.
PLAY button
5.
STOP button
6.
DISPLAY (screen display) button
7.
START/STOP (recording start/stop)
button
8.
PAUSE button
9.
b / B / v / V /ENTER buttons
Notes
• The DATA CODE, T/W (zoom), and MODE buttons
are not used with this recorder.
• To avoid malfunctions, the remote control function is
automatically deactivated when the recorder is turned
off. Activate the function each time when required
after you turn the recorder on.
Replacing the battery in the IR Remote
Commander
Use a commercially available CR2025 lithium
battery. Do not use any battery other than a
CR2025.
1
Press the tab inward and grasp it with
your fingernail to pull out the battery
case.
2
Insert the new battery with its + side
facing up.
3
Insert the battery case until it clicks into
place.
8 Part Identification
WARNING
• Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
• Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
(fast reverse
manufacturer.
When you dispose of the battery, you must obey
the law in the relative area or country.
Tab