Table of Contents
Advertisement
AUDIO SET
Menu items
Subitems and setting values Contents
Limiter Mode
Audio Level CH1
Audio Level CH2
AGC Spec
CH1&2 AGC Mode
CH3&4 AGC Mode
48
Setup Menu List
Off /–6dB /–9dB / –12dB /
–15dB / –17dB
AUTO / Manual
AUTO / Manual
-6dB / -9dB / -12dB / -15dB /
-17dB
Mono / Stereo
Mono / Stereo / Off
Select the limiter setting to use on large input signals when
[Audio Level CH1] to [Audio Level CH2] are set to [Manual].
[Off]: Do not use.
[-6dB] / [-9dB] / [-12dB] / [-15dB] / [-17dB]: Select the level
at which the limiter will be activated.
Tip
• The limiter limits the peak components of audio signals
with wide disparities in levels and compresses audio that
exceeds the specified level to prevent excessive outputs.
• This setting is only enabled when the input source is set to
[Ext].
Select the audio level adjustment method for the CH-1
AUDIO IN connector.
[AUTO]: Automatic adjustment (AGC)
[Manual]: Manual adjustment
Tip
This setting is only enabled when the input source is set to
[Ext].
Select the audio level adjustment method for the CH-2
AUDIO IN connector.
[AUTO]: Automatic adjustment (AGC)
[Manual]: Manual adjustment
Tip
This setting is only enabled when the input source is set to
[Ext].
Select the level at which AGC (auto gain control) controls the
audio level of the AUDIO IN connectors.
Tip
This setting is only enabled when the input source is set to
[Ext].
Select the automatic adjustment method that is used for the
input levels of the analog audio signals that are recorded to
CH-1 and CH-2 from the AUDIO IN connectors.
[Mono]: Adjust separately for each channel.
[Stereo]: Adjust in stereo mode.
Tip
This setting is only enabled when the input source is set to
[Ext].
Select the automatic adjustment method that is used for the
input levels of the analog audio signals that are recorded to
CH-3 and CH-4 from the AUDIO IN connectors.
[Mono]: Adjust separately for each channel.
[Stereo]: Adjust in stereo mode.
[Off]: Do not perform automatic adjustment.
Tip
This setting is only enabled when the input source is set to
[Ext].
Hide quick links:
Advertisement
Table of Contents
