Removing And Replacing The Keypad Assembly - Motorola V6 Service Manual

Digital wireless telephone

Hide thumbs Also See for V6:

Table of Contents

Disassembly

Removing and Replacing the Keypad Assembly

Remove the battery cover, battery, SIM, rear housing, antenna, transceiver board assembly,

flip assembly cover, and camera assembly, as described in the procedures.

The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when

handling.

Disassemble the keypad from the transceiver front housing by removing the two bottom

tabs from the slots in the housing. Rotate the keypad in place such that the remaining 6

tabs are removed from the remaining slots.

Figure 14. Removing and Replacing the Keypad Assembly

Figure 15. Removing and Replacing the Keypad Assembly

To replace, assemble the keypad into the transceiver front housing by aligning the two

bottom tabs to the slots in the housing. Rotate the keypad in place such that the remaining

6 tabs are inserted into the remaining slots.

Ensure the 6 tabs are fully inserted into the transceiver housing.

With the flip open, place the assembly in the press fixture with the keypad/flip facing down.

Operate the press. The keypads flex tail and connector should be folded away from the

front housing.

October 26, 2006

6809505A64-O

061430o

Table of Contents