Motorola V6 Service Manual page 27

Level 1 and 2 Service Manual
7. Carefully lift the display lens away from the flip assembly.
Figure 13. Removing the Display Module Assembly
8. To replace, align the display module assembly to the flip assembly.
9. Carefully lower the display module into the flip assembly. Ensure that all of the display
none of the display assembly components are damaged.
10. Align the flip display flex to the flex connector on the flip display assembly and gently
press down on the flex connector until properly seated.
11. Insert the 2MP imager mounting screws and tighten to a torque of 0.6 inch-pounds.
12. Replace the camera assembly, flip assembly cover, transceiver board, rear housing,
antenna, SIM, battery, and battery connector as described in the procedures.
October 26, 2006
Disassembly
061430o
23