Starting Output - Roland VersaCamm VS-640 User Manual

Starting Output

When the operation of p. 62, "Getting Ready to Receive Data from a Computer" is completed, you can start
output. To output, the following procedure is required
Creating Output Data
Create the output data using the application software like Adobe Illustrator and like that. For information on
how to create the data, refer to the documentation of your application software.
Sending the Output Data to This Machine Using the Software RIP.
Use the included software RIP "Roland VersaWorks." For information on how to install and use Roland Versa-
Works, refer to "Roland VersaWorks Quick Start Guide" and HELP of Roland VersaWorks.
If using the white ink and metallic silver ink, refer to "SPECIAL COLOR INK GUIDE. "
 Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and catch
on the print head.
 During output, never touch the media that's already been discharged. Doing so may obstruct media feed
or cause the media to rub against the heads, which may result in a paper jam or damage to the heads.
 Keep the loading lever raised when the machine is not in use.
If Ink Runs Out
When ink runs out, a warning beep sounds and a slot number of which ink runs out is displayed on the
display screen.
 P. 69, "How to Replace Ink Cartridges"
Before you perform lengthy printing, check the amount of ink remaining in the ink car-
tridges.
Before you perform lengthy printing, check the amount of ink remaining in the ink cartridges. When ink
runs out and printing is paused, the coloring at the seam may be altered when printing resumes.
 P. 68, "Checking for Remaining Ink"
Points that must be observed
Outputting
2
63