Interference With Vehicular Electronics; Preparation When Drilling Holes; Vehicles Powered By Liquefied Petroleum Gas; Radio Installation In Gas Or Fuel Tankers - Tait TM9100 Installation Manual

Interference with Vehicular Electronics

Examples of vehicular electronic devices that may be affected by RF
energy are:
■
■
■
■
If the vehicle contains such equipment, consult the vehicle manufacturer or
dealer to determine whether these electronic circuits will perform normally
when the radio is transmitting.

Preparation when Drilling Holes

Vehicles Powered by Liquefied Petroleum Gas

Radio Installation in Gas or Fuel Tankers

Special conditions must be observed when installing a radio on gas and fuel
tankers. Consult your radio provider or Tait-accredited service center for
more details.

Negative Earth Supply

The radios are designed to operate only in a negative earth system.
TM9100 110W Mobile Radio Installation Guide
© Tait Limited October 2012
Warning
Some vehicular electronic devices may be prone to
malfunction due to the lack of protection from RF energy when
your radio is transmitting.
electronic fuel injection systems
electronic anti-skid braking systems
electronic cruise control systems
indicators.
Warning
When drilling holes in the vehicle, check that drill-
ing at the selected points will not damage existing wiring, fuel
tanks, fuel lines, brake pipes, or battery cables.
Warning
Radio installation in vehicles powered by LPG
(liquefied petroleum gas) with the LPG container in a sealed-off
space within the interior of the vehicle must conform to the
National Fire Protection Association Standard NFPA 58.
This standard states that the radio equipment installation must
meet the following requirements:
The space containing the radio equipment shall be
■
isolated by a seal from the space containing the LPG
container and its fitting.
Outside filling connections shall be used for the LPG
■
container and its fittings.
The LPG container space shall be vented to the outside of
■
the vehicle.
Safety Warnings 7