FLASH pHoToGrApHY
TAKING pHoToGrApHS wITH THE BUILT-IN FLASH UNIT
The Leica X2 is equipped with a built-in flash unit (1.5) that rests hidden in the
To do so, push the release slider 1.17 towards the camera center. The spring-
loaded flash unit then unfolds into its working position whereby it is also
switched on. Whenever you do not want to use the flash, simply keep it re-
tracted or carefully push it down until it clicks into place in its home position.
white. Initially it may flash in red fore a short while instead to indicate that it
is not yet fully charged and therefore not ready.
1.5
For this purpose, a metering flash is triggered immediately before the main
flash. The amount of light reflected then determines the strength of the main
flash.
Note:
eting (see p. 132). Correspondingly, the flash indication will not appear even if
FLASH ModES
Press the right
direction button (1.24), and in the appearing menu, select the
desired flash mode. This can be done alternatively with the setting ring (1.22),
right
direction button again.
Confirm the setting by pressing either the shutter release button (1.8) or the
MENU/SET
button (1.25).
AUToMATIC FLASH ACTIvATIoN –
This is the standard mode. The flash is always fired automatically when,
or in poor weather.
134
-