KitchenAid KHWS01PMT / WH Technical Education page 57

19. Using the procedure in step 13, remove
the two front shock absorbers from the
tub.
20. Lift the tub and basket assembly and un-
hook the two suspension springs, then
remove the assembly from the washer,
and place it front-down on a padded sur-
face so that the back pulley faces up.
NOTE: The suspension springs are in-
stalled in the front slots of the cabinet, as
well as in the tub. Do not use the back
slots; they are used with other models.
Front Slot
Front Slots
21. Remove the 15/16" hex-washer nut from
the drive pulley and remove the pulley
from the basket shaft.
Drive Pulley
Front Slot
Drive Pulley Nut
4-27
22. Mark the edges of the 23 tub clamps with
a pencil so that you can reinstall the clamps
in the same locations later.
23. Use a screwdriver blade, and pry off the 23
tub clamps.
Tub Clamp
Pencil Marks
Tub Clamp
Continued on the next page.
Screwdriver
Pry Clamp Out