KitchenAid KHWS01PMT / WH Technical Education page 16

INSTALLING THE PEDESTAL
WARNING
Excessive Weight Hazard
Use two or more people to move and
install pedestal.
Failure to do so can result in back or
other injury.
1. Open the pedestal drawer, and remove
the envelope taped inside the drawer.
This envelope contains four (4) #12 x 5/8"
(1.6 cm) hex-head sheet metal screws
that will be used in step 4.
2. Remove the phillips screw from both
drawer slides and save the screws. Re-
move the drawer from the slides and set it
aside. Push the drawer slides back into
the pedestal.
3. Remove the four feet from the washer, but
DO NOT install the feet that were supplied
with the new washer.
4. Partially install the two lower hex-head
sheet metal screws. Leave a space of
about 3/8" (1 cm) between the screw head
and the bottom of the washer.
Washer Bottom
Install Screws
5. Move the pedestal against the washer
bottom, and slide the pedestal's keyhole
slots over the lower two partially installed
screws.
Position the pedestal toward the front of
the washer and install the two remaining
hex-head sheet metal screws. Do not
tighten completely.
Align the sides of the pedestal so that they
are even with the sides of the washer.
Reach inside the pedestal drawer open-
ing, and securely tighten all four pedestal
screws.
6. Tip the washer and pedestal assembly
back to an upright position and remove
protective cardboard.
7. Slide the washer close to its final location.
8. Follow the Installation Instructions that
were supplied with the washer, and finish
installing or reinstalling the unit.
9. Locate the 1/4" hex nut on the top of each
pedestal foot. Reach inside the pedestal
and use a ratchet or open-end wrench,
and adjust the feet up or down, as neces-
sary to level the washer and pedestal.
2-8
lower screws in
keyhole slots