KitchenAid KHWS01PMT / WH Technical Education page 35

7. To remove the door lock/switch as-
sembly:
a) Remove the bellows retaining wire (re-
fer to steps 5 and 6 for the procedure).
b) Pull the bellows out and remove the
three T-20 torx screws and flat wash-
ers from the door lock/switch assembly.
Door Switch
(1 Screw)
Door Lock
Switches
(2 Screws)
c) Push the switch assembly out of the
front panel and then slide the assem-
bly tabs from the connector holder.
d) Disconnect the three wire connectors
from the switch terminals and remove
the assembly.
2-Wire 3-Wire
Connector Connector
Door Lock/Switch Assembly
Switch Assembly Tabs
Connector
Holder
4-Wire
Connector
8. To remove the front panel and bellows:
a) Remove the top cover and the console
(see page 4-2 for the procedures).
b) Remove the bellows retaining wire (re-
fer to steps 5 and 6 for the procedure).
c) Pull the bellows off the lip of the front
panel.
d) Remove the door lock/switch assem-
bly (see step 7).
e) Close the washer door.
f) Remove the four T-20 hex-head torx
screws from the top and bottom of the
front panel and remove the panel from
the unit.
Continued on the next page.
4-5
Remove Bellows
From Panel Lip
Front Panel
Top Screws
Bottom Screws