KitchenAid KHWS01PMT / WH Technical Education page 58

24. Lift the rear half of the tub off the front half.
25. Lift the basket from the front half of the tub.
Basket
Front Half Of Tub
Rear Half Of Tub
4-28
26. To replace the heater element wire holder,
remove the T-20 torx screw.
27. To replace the tub gasket, pry the gasket
out of the slot and remove it. NOTE: The
basket hub is molded into the rear half of
the tub. If it is worn and needs to be
replaced, you will need to replace the rear
half of the tub.
Heating Element
Wire Holder
Basket Hub
Tub Gasket