KitchenAid KHWS01PMT / WH Technical Education page 56

14. Remove the screw from the green ground
wire eyelet and remove the wires from the
clips in the tub.
Ground Screw
Unhook Ground Wire
15. Cut the two wire ties at the front of the tub,
and pull the cut ties out of the standoffs.
NOTE: Be careful not to cut the wires
inside the wire ties.
Wire Ties (In Standoffs)
16. At the front of the washer, remove the six
T-20 hex-head torx screws (total) from the
top front brace and remove the brace from
the washer.
IMPORTANT NOTE: When you remove the
bottom front counterweight in the following
step, be sure to support it with one hand while
you remove the screws with the other hand;
otherwise, the weight will fall, and could cause
an injury or damage the floor covering.
17. While supporting the bottom front counter-
weight with one hand, remove the three
1/2" hex-head bolts with the other hand,
and remove the weight.
18. Remove the three 1/2" hex-head bolts
from the top front counterweight, and re-
move the weight.
SUPPORT WEIGHT
WHILE REMOVING
4-26
Top Front Brace
Top Front Counterweight
Bottom Front
Counterweight