Steel City 50126SC User Manual page 18

2. Once the belt is installed, confirm that the pulleys
are aligned using a straight edge on the outer face
of both pulleys. SEE FIG.7
necessary, please loosen 2 set screws, move pulley
into alignment and secure the 2 set screws.
SEE FIG.7-1
FIG.7-1
3. Install one M8 Hex Nut (E) onto the motor
tensioning bolt (F) and thread the bolt into the base
of the bandsaw. SEE FIG. 8.
4. Once the tensioning bolt is installed, push the
dampening washer(G) onto the end of bolt
5. Tighten the motor tensioning bolt until it can comes
in contact with the motor plate. Continue tightening
until there is about 1" deflection in the belt when
squeezed at its midpoint. Once the correct belt
. If an adjustment is
Fig.7
tension is achieved, tighten hex nut from step 3 until it
bottoms out against the base.
Fig.8
F
E
G
6. Fasten the pulley cover (H) to the bandsaw using the
4pcs pan head flange screws.
7. Install the Access Panel using 4pcs M5X10mm Hex
head cap screws(I).
Fig.9
H
I
18
SEE FIG. 9.
SEE FIG. 9.