MOUNTING THE TABLE
1. To install the dust chute(A) onto lower door cover
using 2pcs M4.8X16mm screws. SEE FIG.10-1
A
2. Feed the blade through the slot in the table.
SEE FIG.10
Fig. 10
3. Once the blade reaches the center hole of the table,
rotate the table 90 degrees so that the
miter slot is towards the right of the machine.
3. Position the two threaded bolts so that they line up
Fig.11
FIG.10-1
19
with the holes in the trunnion. Once the bolts are
through the holes, fasten the table using the two
Table lock knobs (B). SEE FIG. 11.
B
B