Commissioning The Dialler Panel - PSA Supa8 User Manual

Commissioning the Dialler Panel

Austel Requirements:
Austel requirement's state that all Dialler Panels connected to the Telephone Network must have
the Telephone connection and termination work performed and completed by a current Austel
Licence Holder.
To Assign for Local Dialling (to a nominated telephone number) for Self
Step 1:
On Keypad
Enter programming mode:
Step 2:
On Keypad
To set up Personal Reporting format:
Step 3:
On Keypad
Re-enter programming mode:
Step 4:
On Keypad
Entering of required telephone number/s.
st
1 Telephone Enter:
nd
2 Telephone Enter:
Note: (a) The above numbers are examples only. You must enter the correct numbers to dial
according to the Home owner's requirements. A maximum of two telephone numbers
can be programmed.
(b) The phone numbers can consist of a mix of mobile phones numbers and local phone
numbers. Only one phone number can be programmed if required.
#6
(c)
*
(d) completes address (allows next address).
Step 5:
Exit programming:
SUPA8 Quick Setup
Monitoring Purposes.
You are now in Programming Mode (ON-LINE light will flash).
Enter:
Followed by:
Enter:
128 0391234567 #6 *
144 0411234567 #6 *
is used to finish the phone number.
On Keypad
Enter:
2580 7
250
(address number)
2578
(cancels the programming mode)
2580 7
*
5