Programming User Codes - PSA Supa8 User Manual

Programming User Codes

Use the Master User Code to enter and delete user codes as follows. The
Master User Code can re-program other codes as well as turning the SUPA8
ON and OFF.
There are 14 user codes plus the Master User Code. All codes are four digits in
length. Do not program two codes identically. If two codes are the same, only
the lower numbered code will be active. (For example, if user code 3 and 9 are
both programmed as 1234, the SUPA8 will only recognise user code 3).
____
1.
(All Zone lights will flash - waiting for a command)
7
........................................ To enter program mode
2.
(ON-LINE lights flashing indicates program mode)
___
3.
See the table of addresses on page 20.
(The existing User Code, if any, will be displayed digit by digit.
If the User Code you are programming is currently blank, lights 7 & 8 will
be on.)
____
4.
Enter each digit slowly and wait for the keypad to beep after each digit is
entered. The ON-LINE light will be flashing if all digits have been entered
correctly.
(If you make a mistake at this stage, press
*
........................................ To exit program mode
5.
SUPA8 User Manual
....................... Your Master User Code
............................. Address for the User Code
......................... Enter a four digit code
*
to go back to step 3)
22