Supa8 Indicator Lights; Keypad Beeper Operation - PSA Supa8 User Manual

SUPA8 Indicator Lights

Listed below are the use of the indicator lights when in normal operation.
Keypad Light ON
Light
Dialler on line
On-Line
Battery Charge Voltage Low
Low Batt
Power not connected
AC Fail
On SUPA8 is ON (Away mode)
Zone 1 - 8 Unsealed, Manual or Auto
isolated
Note that the status of the Zones will always be displayed unless disabled
by the installer. The Low Batt and AC Fail lights will show the current
state of these inputs, however the alarm (or restore) condition may have to
be present for a period before a report is initiated.
If the dialler fails to communicate, the On-Line light will remain flashing
until the next time the system is turned OFF.
All Zone lights on plus a continuous beeper
Means the keypad is locked out for 60 seconds caused by 4 consecutive
incorrect code entries.
All Zone lights flashing
Indicates a legal code has been entered (or the
SUPA8 expects another key to be pressed to select the desired function
within 10 seconds.
To cancel simply wait 10 seconds or press the

Keypad Beeper Operation

The keypad beeper will sound under the following circumstances:
SUPA8 User Manual
Light OFF
Dialler not on line
Battery OK
Power OK
SUPA8 is OFF
Zone is sealed
10
Light Flashing
Dialler had problems
Had Low Batt alarm
Had AC fail alarm
SUPA8 is ON (Home
mode)
Had alarm
#
key pressed) and the
*
key.