Supa8 Operation; Keypad Key Functions; Operation Of All Keys - PSA Supa8 User Manual

SUPA8 Operation

Keypad Key Functions

After a code is entered or the
pressed, you have 10 seconds to select the
operation you wish to perform. During this
time all 8 Zone lights will flash to indicate
that a key should be pressed. If no key is
pressed within 10 seconds, the keypad will
revert to idle mode. Enter your code to start
again.
*
The key is always used as the "clear
key" to abort the current operation.

Operation of all keys

PANIC
1
Key
Enter a User Code followed by
function. The Panic function can trigger the siren or strobe light or dialler
as programmed by your installer.
DURESS
2
Key
Enter a User Code followed by
function. The Duress function can trigger the siren or strobe light or dialler
as programmed by your installer.
TEST
3
Key
Enter a User Code followed by
function. The Test function is used to test the dialler by sending a test
transmission to the programmed telephone numbers. This function is only
available if your system is programmed to report alarms to a monitoring
station.
SUPA8 User Manual
#
key is
1
or enter
2
or enter
3
or enter
12
# 1
to trigger the Panic
# 2
to trigger the Duress
# 3
to trigger the Test