2.3.4
Partner Application Platform
The Mediant 1000 can also host a flexible platform for partner applications. The open platform on
the Mediant 1000 offers partners the option to host their own applications (e.g., IP-PBX or call
center application) using a powerful, low-power consumption processor and hard disks to provide
a complete solution within the Mediant 1000 chassis.
2.3.4.1
Connection Module (CM)
Figure 2-11
Item #
1
RS-232 port, Molex 3 pin connector
2
General purpose LED
3
HDD 2 activity LED
4
HDD 1 activity LED
5
iPMX power LED
6
Type A USB connector
2.3.4.2
iPMX Module
The iPMX module (shown in
an embedded Intel
hosted applications. The iPMX module is connected to the W1 on the rear end. The processor is
connected to a hard disk drive (described in Section
of the W1 chassis (second hard disk is optional). Both hard disks are connected to the W1 mid-
plane via an edge connector.
Note:
Mediant Series and TP-1610 H.323
shows the front panel of the CM module (located on the Mediant 1000 front panel).
Figure 2-11: Front View of the CM Module
3
1
2
Table 2-16: CM Module Component Descriptions
Figure
TM
Pentium-M
The iPMX module includes a backup battery that is responsible for retaining
the CMOS setup configuration. The battery lasts for 18 months of non-
operating conditions. When empty (the CMOS configuration returns to its
default). Replace with Lithium battery model CR-1225.
4
5
Component Description
2-12) is located on the Mediant 1000 rear panel. It includes
TM
Celeron ULV 600 MHz processor platform for third-party
2.3.4.3
38
Mediant Series and TP-1610 H.323
6
on page 39) located on the rear side
Document #: LTRT-69903