Cleaning; Troubleshooting - FANATEC Clubsport User Manual

Clean only with a dry or slightly damp cloth. Using cleaning solutions may dam-
age your Universal Hub.
The Universal Hub must not be modified differently than described in this man-
ual. Endor
®
hardware, software and firmware contained in the controller. In case difficulties
occur in connection with utilization of the Universal Hub, please use the follow-
ing guide for elimination of errors. On the website www.fanatec.com/support
you will find further details and contact data.
If the Universal Hub is not working properly:
Problem description
After switching on the ClubSport Wheel Base
with attached Universal Hub the auto calibration
is not working properly.
The driver window does not show the attached
rim.
30
8

TROUBLESHOOTING

9
AG expressly prohibits analysis and utilization of the electronics,

CLEANING

Solution
Make sure that you have updated your ClubSport
Wheel Base to the latest firmware version which
can be downloaded from
www.fanatec.com/support.
Try to use another rim like the RFormula or
RBMW. If the auto calibration is not working
properly with this rims the ClubSport Wheel Base
might be damaged.
Make sure that you have updated your ClubSport
Wheel Base to the latest firmware version which
can be downloaded from www.fanatec.com/
support.
Check the pins inside the quickrelease of the
Universal Hub, these must not be bent or dam-
aged.
Try to use another rim like the RFormula or
RBMW. If this is also not detected the ClubSport
Wheel Base might be damaged.