FANATEC Clubsport User Manual page 11

S1
N1
First you need to take off the frontplate of the
Universal Hub by loosening the four screws
on the backside as described above. Then
choose the holes where you want to mount
a button box or the FunkySwitch
note that the holes with gears must be used
for mounting of the rim! Put on the button
box lever or FunkySwitch
side of the frontplate. Then use the special
screw S1 (M5 x 11 mm) and put it through
the lever's hole and then through the chosen
hole on the frontplate. Turn on a nut N1 (M5
x 7.8 mm x 4.7 mm) onto the screw gears
from the inside of the frontplate. Adjust the
lever position according to your favour and
to the used rim and then tighten the nut N1
on the screw S1. The position of the button
box or FunkySwitch
Then connect the cable of the button box or the FunkySwitch
socket on the electronics. Please see further description about the sockets at
the end of this chapter as well as chapter 7 of this user manual.
11
. Please
TM
lever on the out-
TM
is fixed now.
TM
S1
N1
to the specified
TM