YASKAWA Varispeed G7 Instruction Manual page 358

Storing Inverter Set Values in the Digital Operator (READ)
To store Inverter set values in the Digital Operator, make the settings using the following method.
Set 03-02 (Read permitted selection) to 1 (read permitted).
Step
Digital Operator Display
No.
1
2
3
4
5
6
INV→OP READING
7
8
An error may occur while saving to memory. If an error is displayed, press any key to cancel the error display
and return to the o3-01 display.
Error displays and their meanings are shown below. (Refer to Chapter 7 Errors when Using the Digital Oper-
ator Copy Function.)
Error Display
READ IMPOSSIBLE
-152
6
Table 6.1 READ Function Procedure
-ADV-
** Main Menu **
Press the Menu Key, and select advanced programming mode.
Programming
-ADV-
Initialization
Press the DATA/ENTER Key, and select the constants monitor display.
A1 - 00=1
Select Language
-ADV-
Display o3-01 (Copy Function Selection) using the Increment Key and Decrement
COPY Function
Key.
o3 - 01=0
Copy Funtion Sel
-ADV-
Copy Funtion Sel
Press the DATA/ENTER Key, and select the constants setting display.
o3-01= 0
*0*
COPY SELECT
-ADV-
Copy Funtion Sel
Change the set value to 1 using the Increment Key.
o3-01= 1
*0*
INV→OP READ
-ADV-
READ
Set the changed data using the DATA/ENTER Key. The READ function will start.
-ADV-
READ
If the READ function ends normally, End is displayed on the Digital Operator.
READ COMPLETE
-ADV-
Copy Funtion Sel
The display returns to o3-01 when a key is pressed.
o3 - 01=0
*0*
COPY SELECT
PRE
You are attempting to set o3-01 to 1 while o3-02 is set to 0.
Explanation
Meaning