Mitsubishi Electric Apricot LS 550 Owner's Handbook Manual page 59

Computer
Table of Contents

Advertisement

3. Place the SIMM in a suitable anti-static packaging.
To install a SIMM
1. Take the SIMM out of its anti-static packaging. Hold it by its
2. Place the SIMM in the socket at a 15
3. Pushing gently on its top corners, stand the SIMM upright in
4. If the SIMM will not fit easily, remove it and start again.
5. Repeat these steps for each SIMM you want to install.
Reconfiguring the system
The first time you turn on the computer after adding or removing
SIMMs the memory change will be automatically detected by the
power-on self-test (POST). All you have to do is confirm the new
edges and avoid touching the metal contacts.
The SIMM is not symmetrical. There are small notches in one
end and also slightly off centre along the connection edge, as
shown above. It will only fit into the socket one way.
the socket until the pegs of the socket engage the holes on the
SIMM and the metal clips hold both ends of the SIMM firmly
in position. Do not use excessive force.
S y s t e m U p g r a d e s
angle to the vertical.
o
LS/VS 550 OWNER'S HANDBOOK
5/5

Advertisement

Table of Contents
loading

Table of Contents