Djustment, Start & Stop; Adjustment; Step 1: Reset The System; Step 2: Set Low Fire Air - Eclipse Winnox WX Series Installation Manual

djustment, Start &
Stop
TRODUCTIO
JUSTMENT
tep 1: Reset the system
n this chapter , you will find instructions on how to adjust, start,
and stop the burner system. Become familiar with burner
control methods before attempting to make adjustments..
anger:
The Winnox burners, described herein, are
designed to mix fuel with air and burn the
resulting mixture. All fuel burning devices are
capable of producing fires and explosions if
improperly applied, installed, adjusted, controlled,
or maintained.
o not bypass any safety feature; fire or explosion
could result.
Never try to light a burner if it shows signs of
damage or malfunction.
Adjustment steps:
1.
eset the system
2.
Set low fire air
3.
Ignite the burner
4
. Set low fire gas
5
. Set high fire gas
6.
Verify settings
Reset procedure:
1.
Set the low gas pressure switch to 20% below the “Main
gas inlet pressure” range as specified in the appropriate
data sheet.
2
. Set the high gas pressure switch to 20% above the “Main
gas inlet pressure” range as specified in the appropriate
data sheet.
3.
Close all the burner gas valves, manual and automatic.
4.
Try to ignite the burner; be sure the flame monitoring
system indicates a flame failure.
clipse Winnox WX Series v1, Installation Guide No. 111, 8/26/05
5