Connecting The Extender For Hdmi 1.3 Over Cat5 With Ethernet; Wiring Diagram - Gefen EXT-HDMI 1.3-CAT5-ELR User Manual

CONNECTING THE EXTENDER FOR
HDMI 1.3 OVER CAT5 WITH ETHERNET
1. Connect the Hi-Def source to the Sender Unit using the included HDMI cable.
2. Use an HDMI cable to connect the HDTV display to the Receiver Unit.
3. Connect the Ethernet device/router to the Ethernet input port on the Sender
unit using a CAT-5, CAT-5e or CAT-6 cable. Connect the Ethernet output port
on the Receiver Unit to the remote device/router with a CAT-5, CAT-5e or
CAT-6 cable.
4. Use a CAT-5 or CAT-6 cable up to 330 feet (100 meters) to connect the
Sender Unit and Receiver Unit.
NOTE: If terminating network cables in the fi eld, please adhere to
the TIA/EIA568B specifi cation (see page 11).
5. Connect the included 5V DC Locking Power Supplies to the Sender Unit
and Receiver Unit. Do not overtighten the locking connectors. Plug the
two power supplies into an available electrical outlet using the included AC
power cords. The Sender and Receiver units will now power up.
NOTE: If the power LED indicator on the receiver unit is not on,
check to make sure that the CAT5 cables are not crossed (Ethernet
to Link instead of Ethernet to Ethernet, for instance).
Wiring Diagram for the Extender for HDMI 1.3 over CAT5 with Ethernet
Hi-Def
IR Emitter
Source
Ethernet
Source
Sender
CAT5 CABLE
HDMI CABLE
ETHERNET
IR Extender
Receiver
HD Display
with Ethernet
EXT-HDMI1.3-CAT5-ELR
8
(Up to 300 ft)
IR